prolog_jiti.pl -- Just In Time Indexing (JITI) utilities

This module provides utilities to examine just-in-time indexes created by the system and can help diagnosing space and performance issues.

To be done

- Use print_message/2 and dynamically figure out the column width.

 jiti_list is det

 jiti_list(:Spec) is det

List the JITI (Just In Time Indexes) of selected predicates. The predicate jiti_list/0 list all just-in-time indexed predicates. The predicate jiti_list/1 takes one of the patterns below. All parts except for Name can be variables. The last pattern takes an arbitrary number of arguments.

• Module:Head
• Module:Name/Arity
• Module:Name

The columns use the following notation:

• The Indexed column describes the argument(s) indexed:
  • A plain integer refers to a 1-based argument number
  • A+B is a multi-argument index on the arguments A and B.
  • P:L is a deep-index L on sub-argument P. For example, 1/2:2+3 is an index of the 2nd and 3rd argument of the 2nd argument of a compound on the first argument of the predicate. This implies x and y in the head p(f(_,g(_,x,y)))
• The Buckets specifies the number of buckets of the hash table
• The Speedup specifies the selectivity of the index
• The Flags describes additional properties, currently:
  • L denotes that the index contains multiple compound terms with the same name/arity that may be used to create deep indexes. The deep indexes themselves are created as just-in-time indexes.
  • V denotes the index is virtual, i.e., it has not yet been materialized.

 iarg_spec(+Position, +Args)//[private]

 jiti_suggest_modes is det

 jiti_suggest_modes(:Spec) is det

Propose modes for the predicates referenced by Spec. This utility may be executed after a clean load of your program and after running the program. It searches for static predicates that have been called and (thus) have been examined for candidate indexes. If candidate indexes have not been materialized this implies that the predicate was never called with a nonvar value for the corresponding argument. Adding a mode/1 declaration may be used to inform the system thereof. The system will never examine arguments for indexing that have been declared as mode -.

Note: This predicate merely detects that some predicate is never called with instantiated specific arguments during this run. The user should verify whether the suggested - arguments are correct and typically complete the mode by changing ? into + (or -) where applicable. Currently, in SWI-Prolog, mode/1 declarations have no effect on the semantics of the code. In particular, a predicate that declares some argument as - may be called with this argument instantiated. This may change in the future.

Arguments:

Spec	- uses the same conventions as jiti_list/1.